I usually end up with several spares after getting boards done (like 20). I can think of some great projects for 20 networked mega128's, but they'll have to wait until after I graduate. So, rather than letting them lie around unused... Contact me if you want a bare pcb (bareboard tested and gold-plated) or a fully populated and tested board.

ATMega128 breakout board

• Oboard 5V 1A regulator
• 8Mhz chip
• JTAG header
• All pins labeled and grouped in ports
• Reset button
• 5x3 smd strip xtal
• Power LED
• Better than similar offerings ;-)

Power Supply
Maximum input voltage (Vin) 15VDC
Minimum input voltage 6VDV
Maximum supply current 1A
Output voltage 5V

Physical Dimensions
Width 55mm
Height 45mm
Board thickness 1.6mm

Gerber set & drill files

USB AVR JTAG clone

ATMega48/88/168 DIP module with integrated 1A power supply

• Accepts Atmel mega48/88/168
• 5x3 smd strip crystal
• 3 terminal debugwire debug interface (ISP also available through SPI port pins)
• Onboard 5V regulator - max 1A
• 600mil wide, 32 pin DIP package
• Provides maximum of 23 I/O lines
  
  

Dual 30A DC motor driver

Based on the VNH2SP30, this board is capable of 30A peak per channel, or 10-15A sustained.

Dual-axis balancing robot controller with integrated inertial sensors, high current motor drivers, bluetooth wireless modem